Penerapan Kaizen System Untuk Efisiensi Pekerjaan Galian Batu Pada Proyek Relokasi Jalan Masyarakat Terdampak Bendungan Bolango Ulu PT. Bumi Karsa
DOI:
https://doi.org/10.25170/jpk.v2i04.6980Keywords:
Automatic Transfer Switch , Pemilihan fasaAbstract
Alternating current electricity is commonly transmitted in two ways, single phase and three phase. Three phase is commonly used in industrial settings for manufacturing lines meanwhile single phase load are powered by tapping one of the three available phases. This research delves into installation of an Automatic Transfer Switch to provide redundant single phase supply using two ATS units wired in a way to automatically tap into any active one phase out of the three phase supply. The result is that dual ATS system is capable of providing single phase electricity as long as there is one active phase out of the three phase supply.
References
Bhuiyan, M. N., Billah, M. M., Bhuiyan, F., Bhuiyan, M. A. R., Hasan, N., Rahman, M. M., Miah, M. S., Alibakhshikenari, M., Arpanaei, F., Falcone, F., & Niu, M. (2022). Design and Implementation of a Feasible Model for the IoT Based Ubiquitous Healthcare Monitoring System for Rural and Urban Areas. IEEE Access, 10, 91984–91997. https://doi.org/10.1109/ACCESS.2022.3202551
Festus, O. E. (2016). Application of electrical phase selector on human relief stand-by change-over switch. Imperial Journal of Interdisciplinary Research, 2(10), 1234–1237.
Halepoto, M. A. J., I. A. ,. &. Abro. (2021). Design and implementation of low-cost automatic transfer switch with interlocking facility. International Journal of Future Generation Communication and Networking, 14(2), 31–40. https://doi.org/10.33832/IJFGCN.2021.14.2.03
Intel, Corp. (2018). Desktop platform form factors power supply design guide. Intel Corporation.
Kumbhare, P. (2018). Auto selection of any available phase in 3-phase supply system. International Journal for Research in Applied Science and Engineering Technology, 6(4), 2029–2033. https://doi.org/10.22214/IJRASET.2018.4343
Lasisi, A. S., H. ,. &. Oladokun. (2014). Elimination of stress and reduction in switching time from mains to back-up power source in power dependent public utilities by automatic mains and phase changer. International Journal of Engineering Sciences & Research Technology, 3(6), 719–726.
Mohiuddin, M. (2013). Performance evaluation and operation of auto load transfer switch. International Journal of Renewable and Sustainable Energy, 2(6), 205–211. https://doi.org/10.11648/j.ijrse.20130206.13
Nikum, K. (2018). Automatic phase changer: A review. International Journal of Engineering Research and Technology, 5(1), 1–3.
Odiba, A. (2017). Developing an automatic switch for home or industrial power supply changeover. British Journal of Applied Science & Technology, 21(4), 1–7. https://doi.org/10.9734/BJAST/2017/32785
Ojo, O. A., K. O. ,. &. Benard. (2025). Design and implementation of automatic transfer switch for power system management. Journal of Energy Technology and Environment, 7(1), 23–29. https://doi.org/10.5281/zenodo.15014501
Oweziem, C., U. ,. &. Obinwa. (2015). Design of automatic power phase selector. International Journal of Engineering and Innovative Technology, 5(2), 43–47. https://doi.org/10.17605/OSF.IO/GFMTZ
Panchal, A. N. (2022). Automatic active phase selector for single-phase load from three-phase supply. Soft Computing Research Society eBooks. https://doi.org/10.52458/978-81-955020-5-9-21
Soni, P., A. ,. Shubham, U. ,. Wakodikar, S. ,. Prasanna, P. ,. &. Gaurkhede. (2020). Automatic phase selector from any available three-phase supply system. International Journal of Advanced Innovative Technology in Engineering, 2(1), 375–378.
