Pengembangan Perangkat Lunak Untuk Akuisisi Data Konsumsi Daya Listrik Dari Power Meter

Authors

  • Ignatius Ginting Department of Electrical Engineering, Faculty of Engineering Atma Jaya Catholic University of Indonesia, Jakarta 12930, Indonesia
  • Melisa Mulyadi Engineer Profession Program, Faculty of Engineering Atma Jaya Catholic University of Indonesia, Jakarta 12930, Indonesia
  • Linda Wijayanti Engineer Profession Program, Faculty of Engineering Atma Jaya Catholic University of Indonesia, Jakarta 12930, Indonesia
  • Ferry Rippun Gideon Manalu Department of Electrical Engineering, Faculty of Engineering Atma Jaya Catholic University of Indonesia, Jakarta 12930, Indonesia

DOI:

https://doi.org/10.25170/jurnalelektro.v17i2.6109

Keywords:

Internet, Node MCU, power meter, Python, ThingSpeak, Three phase

Abstract

Technological developments make it possible to monitor electricity consumption in real-time via the internet. The system developed uses a power meter to collect data, Python to process data and IoT connectivity via NodeMCU ESP8266 to send data to the internet. Python is used so that measurement data can be processed and presented in an easy-to-understand format. The test results show that electrical data measurements can be displayed with an error ranging from 0.04% -11.56%. This is because there is a delay from the time the power meter is measured until the data is displayed on ThingSpeak.

References

PRIYOMBODO, “Target Konsumsi Listrik Masyarakat Tahun 2024 Meningkat,” www.kompas.id, 2024.

F. M. Farhan, E. Rosdiana, I. W. Fathonah, R. A. Sala, “Sistem Pemantauan Dan Pengendalian Daya Listrik secara Real Time Berbasis Mikrokontroler,” Jurnal TEKTRIKA, vol. 7, no. 1, pp. 8-13, 2022.

I. Grout, W. A. P. de Ferreira, and A. C. R. da Silva, “On-Line Electrical Supply Generation Fuel Mix Data Analysis using Python and TensorFlow,” in 2019 International Conference on Power, Energy and Innovations (ICPEI), 2019, pp. 20–23, doi: 10.1109/ICPEI47862.2019.8944972.

R. Lo, dkk, “Penggunaan Bahasa Pemrograman Python dalam Menganalisis Hubungan Kualitas Kopi dengan Lokasi Pertanian Kopi,” Jurnal Publikasi Teknik Informatika, vol. 2, No.2, pp. 100-109, 2023.

M. H. Kurnia, R. E. Saputra, and C. Setianingsih, “High-Low Detection of Sea Water Waves With Multi-Sensor System Based on Iot,” e-Proceeding Eng., vol. 8, no. 5, pp. 6175–6182, 2021.

L. Zhou et al., “Development and design of a data acquisition device for cold standby power meter,” in 2024 IEEE 2nd International Conference on Control, Electronics and Computer Technology (ICCECT), 2024, pp. 322–325, doi: 10.1109/ICCECT60629.2024.10545776.

H. W., Pradana, S. I., Haryudo, “Model Power Metering Berbasis Haiwell Cloud Scada Untuk Efisiensi Energi Listrik,” Jurnal Teknik Elektro, vol. 13, no. 1, pp. 10-20, 2023.

A. B. P. Manullang, Y. Saragih, R. Hidayat, ” Implementasi Nodemcu Esp8266 Dalam Rancang Bangun Sistem Keamanan Sepeda Motor Berbasis IOT,” Jurnal Informatika & Rekayasa Elektronika, vol. 4, no. 2,. 163-170.

Z. Song, Y. Wu, C. Tian, C. Liu, and W. Wang, “The Test Data of Multi-source Transmission and Transformation Equipment are Unified JSON Format File Generation,” in 2021 International Conference on Advanced Electrical Equipment and Reliable Operation (AEERO), 2021, pp. 1–4, doi: 10.1109/AEERO52475.2021.9708143.

R. Jeansoulin, “Data Served by JSONP,” in JavaScript and Open Data, 2018, pp. 229–234.

Downloads

Published

2024-10-12
Abstract views: 30 | PDF downloads: 17